BIS Safety Software
Developing and Using Controls
The course on 'Developing and Using Controls' delves into the various protective measures established for the security of laboratory workers, laying special emphasis on administrative, engineering, and personal protective gear.
The ‘Developing and Using Controls’ course comprehensively focuses on the wide array of safeguards instituted to ensure the safety of laboratory workers, with a specific concentration on administrative, engineering, and personal protective measures.
After successfully completing this course, the learner should gain a detailed understanding of:
- The structure of controls designed for the protection of laboratory personnel.
- The typical safety control methods within each category of control.
- Scenarios where specific safety controls are required to be implemented.
- The necessary personal protection gear suitable for your laboratory setting.
- Develop Controls-Administrative
- Develop Controls-Engineering
- Develop Controls-Personal Protective Equipment (PPE)
Estimated to be around 30 minutes
Tests conducted during this online course aim to reinforce the presented content. A minimum of 80% score is required to earn a certificate of completion. Participants are allowed to retake the course two times if the pass mark is not achieved.
On successful completion of this online course, a certificate of completion can be downloaded and printed.
Course Details
Course Length
This course will take roughly 30 minutes
Passing Mark
To pass this training course, you need to score 80% or higher on the quiz
Certificate
Upon the successful completion of this course a certificate with your name will be stored on your profile and available to print
Additional Training Courses
Hazardous Chemical Information
This curriculum will educate students about everything from the constituents of a hazardous chemical information system to the Internationally Unified System of Classification and...
Skid Steer (Rubber-tired & Track Loader) – Operator Safety (OSHA)
Our online Skid Steer Operator Safety course is intended to aid employers and operators in achieving OSHA-compliant safety training, with a focus on proper...
Spray Finishing
The act of spray painting involves certain risks, both physical and health-related. This module addresses these risks by focusing on flammable and combustible materials...
Download the Training Record Management Buyer’s Guide
Download the LMS Buyer’s Guide
