BIS Safety Software

Digger Derrick Safety

Learn digger derrick safety in this 120-minute online course: fundamentals, tip-over, powerline, rigging and struck-by hazards, roles and competency, standards, pre-operational inspection, setup, safe operation and emergencies. Earn a certificate when you pass.

Digger derrick operations put workers within reach of overhead powerlines, unstable ground, and suspended loads every shift. This digger derrick safety course gives utility, telecommunications, and construction workers the skills to set up equipment correctly, read a load chart, establish exclusion zones, and respond when conditions turn unsafe. The course covers pre-use inspections, lift planning, and safe operating practices that prevent tip-overs, struck-by incidents, and dropped loads on site.

Aperçu du cours

Digger derrick safety training is built around learning modules that walk through every critical phase of a safe operation, from first inspection to emergency response. The course includes these modules:

• Digger Derrick Fundamentals
• Major Hazards (tip-over, overhead hazards, powerline contact, rigging, struck-by)
• Responsibilities, Roles, and Competency
• Applicable Safety Standards and Legal Requirements
• Pre-Operational Inspection
• Setup and Stability
• Load Charts and Lift Planning
• Rigging Awareness
• Safe Operation (work zones, communication, PPE)
• Emergency Procedures

The course opens with equipment fundamentals. You learn what a digger derrick is, how its components interact, and why load position and ground conditions change how the machine behaves.

Hazard recognition and safety standards modules give you a clear picture of the risks specific to digger derrick work. Pre-operational inspection, setup and stability, load charts, and rigging awareness translate directly into the decision points you face before every lift.

Inspection checklist, outrigger pad, load chart, and stop-work call: these are the decision points that matter.

What You’ll Learn

This digger derrick safety course covers the skills you apply before, during, and after every operation on site.

Hazard identification and pre-use inspection

• Identify the major hazards in digger derrick operations, including tip-overs, powerline contact, falling loads, and struck-by incidents.
• Recognize unsafe equipment conditions during a basic pre-use inspection before the machine goes into service.

Stability and outrigger setup

• Explain how stability, leverage, and outrigger configuration affect tip-over risk on different ground surfaces.
• Apply safe setup practices, including correct use of cribbing and outrigger pads, to support lifting operations.

Lift planning and exclusion zones

• Apply lift planning basics covering load awareness, exclusion zone boundaries, and communication roles between operators and ground workers.
• Describe safe operating practices that prevent struck-by injuries and dropped loads during active digger derrick work.

Emergency response and work stoppages

• Recognize when site or equipment conditions are unsafe and require a work stoppage.
• Describe general emergency response procedures to follow when an incident or near-miss occurs on site.

Assessment and certificate of completion

• Demonstrate knowledge retention by achieving the 80% pass mark on the course assessment.
• Earn a certificate of completion that documents your digger derrick safety training.

Observable field actions, documented outcomes, and a certificate in hand.

Who Should Take This Course?

• Utility line workers who set poles, handle transformers, and operate or work alongside digger derricks on overhead line projects and need to recognize hazards before each shift.
• Telecommunications field crews who use truck-mounted drilling and lifting equipment to install infrastructure and must identify equipment hazards before work begins.
• Construction ground workers who enter the work zone during digger derrick operations and must understand exclusion zones, communication signals, and struck-by risks.
• Site supervisors and forepersons responsible for approving lift plans, assigning communication roles, and confirming that setup and stability requirements are met before work begins.
• Equipment operators new to digger derricks who need foundational knowledge of load charts, outrigger setup, and pre-operational inspection before taking on operational duties.
• Safety coordinators and trainers who need a documented, standardized reference for digger derrick hazard recognition and safe operating procedures across their workforce.

Why Take This Course?

Powerline contact, tip-over from unstable ground, dropped loads, and struck-by incidents from rigging failure each carry fatal potential on their own. Digger derrick operations combine all four in a single work zone.

Incidents trace back to specific, preventable failures. Skipped pre-use inspections, incorrect outrigger placement, and workers inside an unestablished exclusion zone are the recurring causes. You address each failure point directly in this course.

Your employer needs a documented training record. Utility, telecommunications, and construction employers must show that workers assigned to digger derrick operations have received structured hazard training. Your certificate of completion creates that record.

Workers who understand load charts, stability principles, and emergency procedures call a stop when ground conditions change, protecting the crew and the equipment.

Key Benefits

• Certificate of completion included upon passing. You receive a documented credential your employer can place in your training file as evidence of digger derrick safety training.
• Tip-over, powerline, and struck-by hazards addressed directly. The course targets the specific failure points behind the most serious digger derrick incidents, so you gain the tools to prevent them before they occur.
• Completed online in 120 minutes. The full course fits within a single shift window, so field crews complete digger derrick training without being pulled off site for a full day.
• Every module ties to a physical job-site task. Each topic connects to a checklist item, a setup step, or a communication role you carry out on actual equipment every shift.
• Priced at $99.99 per learner. A fixed per-seat cost lets your organization budget digger derrick safety training across a crew without variable or hidden fees.

Détails du cours

• Durée 120 minutes
• Format: Online, self-paced
• Pass mark: 80%
• Certificate: Certificate of completion included upon passing
• Price: $99.99 per learner

Foire aux questions

How long does the digger derrick safety course take to complete?

The digger derrick safety course takes 120 minutes in total. You complete it at your own pace, so you can work through it across a single shift window or split sessions as your schedule allows.

What score do I need to pass the digger derrick safety training assessment?

You need 80% to pass. The assessment tests the hazard recognition, inspection, setup, and lift planning knowledge covered throughout the course.

Is a certificate included when I finish the digger derrick safety course?

Yes, the digger derrick safety course includes a certificate of completion, issued when you pass the assessment at 80% or above.

Who should take this digger derrick safety training?

This course is built for utility line workers, telecommunications field crews, construction ground workers, site supervisors, equipment operators new to digger derricks, and safety coordinators who need documented hazard training for their teams.

What topics does the digger derrick safety course cover?

The course covers equipment fundamentals, major hazards including tip-over and powerline contact, roles and responsibilities, applicable safety standards and legal requirements, pre-operational inspection, setup and stability, load charts and lift planning, rigging awareness, safe operation, and emergency procedures.

How much does the digger derrick safety online course cost?

The digger derrick safety course is $99.99 per learner, with no variable or hidden fees added at checkout.

Enrol in the Digger Derrick Safety course today and give your crew the inspection, setup, and lift-planning skills to work safely around this equipment every shift.

Cours de formation supplémentaires

Prácticas de apilamiento y almacenamiento para la construcción

Evitar accidentes en el lugar de trabajo es crucial. Por ello, es vital estar atento y tomar las debidas precauciones mientras desempeñas tus tareas...

Acheter maintenant | $79,99 CAD

Fall Protection in Industrial and Construction Environments

Our online course on Fall Protection delivers crucial insights for employees to ensure their safety when working at heights, complying with all primary training...

Acheter maintenant | $49,99 CAD

Sensibilisation des travailleurs à la santé et la sécurité en 4 étapes

Notre cours de sensibilisation à la santé et la sécurité offre aux participants une compréhension globale de la Loi sur la santé et la...

Acheter maintenant | $0 CAD